Reassembly of the Extruder motor

spartan_155 · Post by **spartan_155** » Wed Aug 05, 2020 5:23 am

I had to dissasemble the front of the Extruder motor to get my filliment feeding properly and now it won't go back together.

Can anyone give me any information about specifically how the spring assembly goes together and how to reattach the fan and heat sink because I attempted to re-screw the screws into their mounting and they are the correct size to thread through the fan but way too small to match the threads in the mount on the engine.

Any advise?

Thanks

Post by **William** » Mon Aug 17, 2020 4:16 pm

Hi,
You can refer to this video to install.

https://www.youtube.com/watch?v=ynNvrsx ... G&index=19

Geeetech

Reassembly of the Extruder motor

Reassembly of the Extruder motor

Re: Reassembly of the Extruder motor