MARLIN 1.1.9 FOR I3 prow

Post Reply
miguelopomelo
Posts: 5
Joined: Sun Apr 12, 2020 12:48 am

MARLIN 1.1.9 FOR I3 prow

Post by miguelopomelo » Mon Apr 20, 2020 2:38 am

Hello
I am trying to load version 1.1.9 to my I3 proW, it has the GT2560A + and it does not have any type of self-leveling, I have tried to load the one from the proB, since it is the only one that I have found already configured, but when making the auto home I It gives an error, I don't know if the entire section of the self-leveling sensors can be disabled in the marlin. Currently I have loaded the firmware of geeetech 1.0.5, but my intention is to change the drivers that it has for some tmc2208, I do not know if there is any later version.
Thanks for your help

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: MARLIN 1.1.9 FOR I3 prow

Post by William » Mon Apr 20, 2020 5:32 pm

Hi,we have not used the marlin 1.1.9, nor have we tested it, so it is recommended that you use our firmware.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

miguelopomelo
Posts: 5
Joined: Sun Apr 12, 2020 12:48 am

Re: MARLIN 1.1.9 FOR I3 prow

Post by miguelopomelo » Tue Apr 21, 2020 1:38 am

Hi.
The truth is that version 1.0.5 of your firmware works quite well, but i need to change the A4988 for some TMC2208 ( my wife cannot bear the noise of the printer and the truth is that I understand her ) I would have to be able to edit that firmware to change the direction of rotation of the motors and I think something else, although if you tell me that only Physically reversing the connectors on the motors would work fine, I could try it.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: MARLIN 1.1.9 FOR I3 prow

Post by William » Tue Apr 21, 2020 9:41 am

Hi,you can change the black and green line order as shown.
M%FVH~(1HA}5Q`}S%Y7P$KL.png
M%FVH~(1HA}5Q`}S%Y7P$KL.png (302.93 KiB) Viewed 8390 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

miguelopomelo
Posts: 5
Joined: Sun Apr 12, 2020 12:48 am

Re: MARLIN 1.1.9 FOR I3 prow

Post by miguelopomelo » Tue Apr 21, 2020 5:21 pm

Thank you very much, I will try it as soon as the TMCs arrive

Post Reply