Page 1 of 1

Z- Height

Posted: Fri Jun 26, 2020 2:09 am
by Scuttle130
Has anyone gotten the Z-Height to stabilize correctly? Every time i try to set it as 3 sheets of paper width, the filament doesn't extrude when the print starts. Occasionally i will get a weak print (one you can crush with your fingers). Most of the time i get nothing coming out of the extruder.

Re: Z- Height

Posted: Fri Jun 26, 2020 6:55 am
by Scuttle130
Here is a picture of my problem... is there a way to set the height? I searched the forum and found ways for other printers, but not the I3 Pro C.

Re: Z- Height

Posted: Fri Jun 26, 2020 6:56 am
by Scuttle130
The forum won't accept my jpgs.