Z- Height

Post Reply
Scuttle130
Posts: 3
Joined: Mon Jun 08, 2020 11:12 pm

Z- Height

Post by Scuttle130 » Fri Jun 26, 2020 2:09 am

Has anyone gotten the Z-Height to stabilize correctly? Every time i try to set it as 3 sheets of paper width, the filament doesn't extrude when the print starts. Occasionally i will get a weak print (one you can crush with your fingers). Most of the time i get nothing coming out of the extruder.

Scuttle130
Posts: 3
Joined: Mon Jun 08, 2020 11:12 pm

Re: Z- Height

Post by Scuttle130 » Fri Jun 26, 2020 6:55 am

Here is a picture of my problem... is there a way to set the height? I searched the forum and found ways for other printers, but not the I3 Pro C.

Scuttle130
Posts: 3
Joined: Mon Jun 08, 2020 11:12 pm

Re: Z- Height

Post by Scuttle130 » Fri Jun 26, 2020 6:56 am

The forum won't accept my jpgs.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest