Z (Vertical) Axis Issues on Setup

Post Reply
Posts: 1
Joined: Sun Mar 29, 2020 4:31 am

Z (Vertical) Axis Issues on Setup

Post by dspatch09 » Fri Apr 10, 2020 10:31 am

I finished setting up the printer today and started up the software and the X and Y axis run fine on the test but the vertical access stalls out. I can see the motors on either side operating independently to even out the X axis but once it lowers about an inch it locks up and stops moving. I can manually spin the motor to continue the movement as a test but I have disconnected the threaded pieces a few times and leveled the X Axis but it continues to catch.

Any suggestions for what I can try? Thank you.

User avatar
Site Admin
Posts: 6191
Joined: Tue Jun 07, 2016 9:38 am

Re: Z (Vertical) Axis Issues on Setup

Post by William » Fri Apr 10, 2020 10:46 am

Hi, You may need to install the left and right z-axis on the same horizontal line
You can refer to: http://geeetech.com/forum/viewtopic.php?f=82&t=60931
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest