adjusted driver voltage from .8 to 1 now x axis dosnt move and x driver gets very hot

Post Reply
Bluesandbox
Posts: 3
Joined: Thu May 09, 2019 5:08 am

adjusted driver voltage from .8 to 1 now x axis dosnt move and x driver gets very hot

Post by Bluesandbox » Thu Feb 27, 2020 8:08 am

I adjusted the voltage for all the drivers from.8 to 1 because the motors could barely push filament (i could easily push manually), now the x-axis doesn't move and the driver for it gets very hot and reads 0.5 volts. I switched the wire to the y-axis and it won't move either, so it isnt the wire or the motor is self

User avatar
William
Site Admin
Posts: 6331
Joined: Tue Jun 07, 2016 9:38 am

Re: adjusted driver voltage from .8 to 1 now x axis dosnt move and x driver gets very hot

Post by William » Fri Feb 28, 2020 11:13 am

Hi,if you swap the position of the motor slot on the motherboard, and then the motor does not run properly, there may be a problem with the motor slot on the motherboard. Is your x-axis corresponding motor inserted into the drive board?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests