Hi,
I found the Pro i3 C GT2560 A+ with BL touch but it doesn't seem to recognise the dual extruders.
Any idea where I could download it ?
Thanks
Thierry
Looking firmware Pro i3 C Board GT2560 A+ with BL touch Dual extruder
Looking firmware Pro i3 C Board GT2560 A+ with BL touch Dual extruder
i3 B + i3 C + i3 M201 + A10 + A10m + A30
(+3 x Kossel)
Mostly PLA
(+3 x Kossel)
Mostly PLA
Re: Looking firmware Pro i3 C Board GT2560 A+ with BL touch Dual extruder
The one referenced in the page heading is OK.
I was just wondering thqt I will be able to move each Extruder separetly using the menu.
It is not the case...
I was just wondering thqt I will be able to move each Extruder separetly using the menu.
It is not the case...
i3 B + i3 C + i3 M201 + A10 + A10m + A30
(+3 x Kossel)
Mostly PLA
(+3 x Kossel)
Mostly PLA