No way to level bed

Mr.Hotwire
Posts: 21
Joined: Mon Jun 24, 2019 9:16 am

Re: No way to level bed

Post by Mr.Hotwire » Wed Jul 10, 2019 10:58 am

Both upper and lower rods are 7.83mm in diamter, both upper and lower locking rings are tight.

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: No way to level bed

Post by William » Wed Jul 10, 2019 11:48 am

Hi, You may need to remove the hot bed and place it in a horizontal position to see if it is uneven.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Mr.Hotwire
Posts: 21
Joined: Mon Jun 24, 2019 9:16 am

Re: No way to level bed

Post by Mr.Hotwire » Wed Jul 10, 2019 1:16 pm

I have checked that the glass is flat, using a straight edge. And the glass is flat.

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: No way to level bed

Post by William » Wed Jul 10, 2019 3:16 pm

Hi, do you have a hotbed under the glass?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Mr.Hotwire
Posts: 21
Joined: Mon Jun 24, 2019 9:16 am

Re: No way to level bed

Post by Mr.Hotwire » Thu Jul 11, 2019 1:24 am

yes, there is a heated bed under the glass. My machine is a Pro C.

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: No way to level bed

Post by William » Thu Jul 11, 2019 9:13 am

Hi, have you checked if the hotbed is level? Remove the inspection on the horizontal plane?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

joshi123
Posts: 1
Joined: Sun Sep 20, 2020 2:07 pm

Re: No way to level bed

Post by joshi123 » Sun Sep 20, 2020 2:09 pm

I set an on the right track edge on the glass bed, and the glass bed its self is level. The glass bed is held to the warmth bed by bulldog cuts, insufficient strain to twist the glass. I checked the two sides of the glass just in the event that one side was thicker in the middle then the opposite side.

Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests