Getting "mintemp triggered system stopped" in Repetier
Posted: Sun May 05, 2019 6:25 am
Hi,
I built my i3 Aluminum not to the full extent as I don't want to use it as a 3D printer. I left out the heated bed and the extruder, so above error will be due to these missing components.
Can anyone tell me how to bypass this in some way.
My intention is twofold:
1) use the extruder stepper to drive a syringe mounted on the extruder carriage, for the purpose of dispensing solder paste
2) mount a milling head on the carriage (connected via a flex to a small milling motor) for the purpose of milling plastic housings
Any help would be welcome.
thx
I built my i3 Aluminum not to the full extent as I don't want to use it as a 3D printer. I left out the heated bed and the extruder, so above error will be due to these missing components.
Can anyone tell me how to bypass this in some way.
My intention is twofold:
1) use the extruder stepper to drive a syringe mounted on the extruder carriage, for the purpose of dispensing solder paste
2) mount a milling head on the carriage (connected via a flex to a small milling motor) for the purpose of milling plastic housings
Any help would be welcome.
thx