Page 1 of 1

What stepper motors are used with the i3Alu - current adjustment

Posted: Mon Feb 11, 2019 9:03 pm
by onki
Hi,

Does anyone knows details (voltage/current) about the stepper motors used with the i3 Alu?
I am using new driver boards (TMC2208) and want to adjust the motor current.

Best regards
Onki

Re: What stepper motors are used with the i3Alu - current adjustment

Posted: Fri Feb 15, 2019 3:57 am
by _kaktus_
Hi.
:mrgreen:
Read the motor designation from the body, enter it here.

Re: What stepper motors are used with the i3Alu - current adjustment

Posted: Mon Feb 18, 2019 10:53 am
by William
You can invert the dir of the motor on Firmware.
Then it will work normal.
;)

Re: What stepper motors are used with the i3Alu - current adjustment

Posted: Mon Feb 18, 2019 10:42 pm
by onki
Hi William,

the direction is OK. I just want to know the nominal current to adjust my new driver boards.
It is a regular I3 Aluminum stepper motor.

Best regads
Onki

Re: What stepper motors are used with the i3Alu - current adjustment

Posted: Mon Feb 18, 2019 10:47 pm
by _kaktus_
Hello.
:mrgreen:

Each stepper motor has an inscribed type. If you don't read it and write it here nobody will help you.