Aluminum Prusa i3 Memory Issues
Posted: Sun Dec 09, 2018 7:46 pm
I have the aluminum i3. When I set my value for the zstep/mm, the controller won't keep the value I've set. If I back out of programming, or if I shut off the unit, it just defaults at 2560...
Also, when the unit is on for 4 or 5 minutes, my screen goes garbled. I have to unplug the machine to get it to reset....
I've updated the firmware, but nothing...
Also, when the unit is on for 4 or 5 minutes, my screen goes garbled. I have to unplug the machine to get it to reset....
I've updated the firmware, but nothing...