the hot-end of my extruder mk8 is no longer able to extrude properly

Post Reply
merlinorn
Posts: 1
Joined: Thu Nov 16, 2017 6:29 am

the hot-end of my extruder mk8 is no longer able to extrude properly

Post by merlinorn » Tue Oct 23, 2018 3:36 pm

I have a problem ... the hot-end of my extruder mk8 is no longer able to extrude properly, I continue problems from hitch, which according to what I have tried do not come from the nozzle blocked but from the throat ... that is, inside the screw where the thread inside the heater, it does not slip any better, what could it be, what should I do? Can you clean? If so how? Or do I have to change it? Thank you

User avatar
_kaktus_
Site Admin
Posts: 1237
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: the hot-end of my extruder mk8 is no longer able to extrude properly

Post by _kaktus_ » Wed Oct 24, 2018 2:37 am

Hello.
:mrgreen:

You've probably got a blockage in this part.
To remove it you will have to disassemble everything.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest