Re: Aluminium i3 extruder element issue (?)
Posted: Wed Oct 03, 2018 1:41 am
- grzałka_głowicy.jpg (168.14 KiB) Viewed 5152 times
Geeetech
Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://www.geeetech.com/forum/
Aluminium i3 extruder element issue (?)
Page 2 of 2
Re: Aluminium i3 extruder element issue (?)
Posted: Thu Oct 04, 2018 8:58 pm
Hello,
so today I have received already spare heating element and in this case it seems to be OK, no connection between leads and housing. Seems that I really had just bad luck for two non compliant pieces. I have already the plastic distances for the board but first I will try to isolate the holes using plastic washers for TO220 transistors. If these fits in the holes, I would not need to drill larger holes in the frame. All I need now is to have some spare time to do it. Lots of other work these days
Regards
Michal
so today I have received already spare heating element and in this case it seems to be OK, no connection between leads and housing. Seems that I really had just bad luck for two non compliant pieces. I have already the plastic distances for the board but first I will try to isolate the holes using plastic washers for TO220 transistors. If these fits in the holes, I would not need to drill larger holes in the frame. All I need now is to have some spare time to do it. Lots of other work these days
Regards
Michal
Re: Aluminium i3 extruder element issue (?)
Posted: Fri Oct 05, 2018 12:34 am
Hello,
Make a reclamation of the two previous exemplars.
If they are damaged they should be replaced immediately.
Head up, it will only be better.
Thanks to various problems you will get to know the equipment faster.
Make a reclamation of the two previous exemplars.
If they are damaged they should be replaced immediately.
Head up, it will only be better.
Thanks to various problems you will get to know the equipment faster.