i3 Aluminium with Sanguinololu and Marlin V.1.1.9 - Help needed

Post Reply
I3dee
Posts: 1
Joined: Fri Aug 17, 2018 9:29 pm

i3 Aluminium with Sanguinololu and Marlin V.1.1.9 - Help needed

Post by I3dee » Tue Sep 11, 2018 3:03 pm

Hi together,
I have just assembled a Geeetech Prusa i3 Aluminium with Sanguinololu board and it is running well now.
However I would like to update the firmware to the new Marlin V1.1.9 and have questions about this.
Today the printer uses this firmware, provided by Geeetech:

"for the upgraded kit using lead screw
Plusa_I3_A_sanguinololu(for the upgraded kit using lead screw).zip
(242.47 KiB) Downloaded 2563 times"

It seems to be quite old version as the configuration files differ much from those of the Version 1.1.9.

Marlin has example configurations for Geeetech printers with GT 2560 boards and for unnamed printers with sanguinololu board but not the combination of both.

Does anybody have a working set of configuration files for Marlin 1.1.9 and i3 Aluminium with Sanguinololu board?


Cheers

Bob

JohnDeere630
Posts: 9
Joined: Sat Oct 01, 2016 8:12 am

Re: i3 Aluminium with Sanguinololu and Marlin V.1.1.9 - Help needed

Post by JohnDeere630 » Fri Sep 28, 2018 5:09 am

I couldn't get anywhere flashing firmware on the sanguinololu board, so I replaced it with the GT2560 board.

Meister_Knobi
Posts: 2
Joined: Tue Oct 09, 2018 3:33 am

Re: i3 Aluminium with Sanguinololu and Marlin V.1.1.9 - Help needed

Post by Meister_Knobi » Tue Oct 09, 2018 3:48 am

I have flashed sucsessfully multiple times, but sadly with very inkonsistant results.

Im Also very interested in an config for an Uptodate Marlin.
JohnDeere630 wrote:
Fri Sep 28, 2018 5:09 am
I couldn't get anywhere flashing firmware on the sanguinololu board, so I replaced it with the GT2560 board.
When you have a working kinda Up To date Marlin FW, even for a GT2560, it would be nice if you could share it with us.

JohnDeere630
Posts: 9
Joined: Sat Oct 01, 2016 8:12 am

Re: i3 Aluminium with Sanguinololu and Marlin V.1.1.9 - Help needed

Post by JohnDeere630 » Wed Oct 17, 2018 11:20 am

Meister_Knobi wrote:
Tue Oct 09, 2018 3:48 am

When you have a working kinda Up To date Marlin FW, even for a GT2560, it would be nice if you could share it with us.
Sorry, I don't check the forum as often as I should. I am attaching a copy of the 1.1.8 Marlin FW configured to work with my machine. It has a BL-Touch bed leveler, a filament sensor using the sensor pin for the Y max, and has the REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER enabled in Configuration.h

Hope this helps....
Attachments
Marlin-1.1.8_GT2560-RevA+.zip
(2.57 MiB) Downloaded 117 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest