Cannot connect printer

Post Reply
jonhconstantine11
Posts: 1
Joined: Mon Sep 09, 2019 2:55 pm

Cannot connect printer

Post by jonhconstantine11 » Mon Sep 09, 2019 3:00 pm

Hello, I just bought a rostock 301 printer.

I installed the driver CDM V2.12.00 driver; and the repetier-host V1.6.0
My device manager says that the USB post is Com3
I copied all the settings from the manual into the repieter-host & click 'connect'
The printer cannot be connected;

what can I do?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Cannot connect printer

Post by William » Mon Sep 09, 2019 3:21 pm

Hi, You may need to do the following checks:

1. You can refer to this for the corresponding driver installation
: https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4

2. When you are ready to connect the printer to the Repetier Host using USB, make sure the printer is turned on and the USB cable is connected properly. Set the baud rate to 115200.

Then connect.

I hope this can help you.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

markcowell23
Posts: 1
Joined: Sun Sep 15, 2019 8:10 pm

Re: Cannot connect printer

Post by markcowell23 » Sun Sep 15, 2019 8:13 pm

jonhconstantine11 wrote:
Mon Sep 09, 2019 3:00 pm
Hello, I just bought a rostock 301 printer.

I installed the driver CDM V2.12.00 driver; and the repetier-host V1.6.0
My device manager says that the USB post is Com3
I copied all the settings from the manual into the repieter-host & click 'connect'
The printer cannot be connected;

what can I do?
I'm facing same error please help me!

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Cannot connect printer

Post by William » Mon Sep 16, 2019 9:04 am

markcowell23 wrote:
Sun Sep 15, 2019 8:13 pm
jonhconstantine11 wrote:
Mon Sep 09, 2019 3:00 pm
Hello, I just bought a rostock 301 printer.

I installed the driver CDM V2.12.00 driver; and the repetier-host V1.6.0
My device manager says that the USB post is Com3
I copied all the settings from the manual into the repieter-host & click 'connect'
The printer cannot be connected;

what can I do?
I'm facing same error please help me!
Hi, Have you tried to install the driver manually?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply