Installing 3D Touch on A30

[156801]

Hi,
just upgraded from Geeetech I3 ProB to a A30 and a good move. I want to instal a 3D Touch which I thought would be plug and play, but do research it does not seem that straight forward.

To install I need to

1. Remove 3 pin socket and install 5 pins see pic's

Extruder Top.jpg (84.51 KiB) Viewed 6479 times

Extruder bottom.jpg (107.21 KiB) Viewed 6479 times

2. Flash firmware with A30_3Dtouch_V3.zip

3. update the UI for LCD after upload the firmware
A30 Refer to this post:
viewtopic ... 65&t=60740

Questions

a, Is this all that is necessary to install the 3D Touch?

b, What way do the wires go on the 5 pins ( Colour left to right )?

c, What type of board is this - ref image

board.jpg (159.99 KiB) Viewed 6479 times

Looking forward to your help.

Robert

[William]

Hi，Your adapter board is an adapter board for capacitive sensors.
and the new motherboard is GT32 pro vd.
the old is GT32 mini.

[156801]

Hi,

Thank you for the reply William.

So the board will be ok for the touch sensor when I solder the 5 pins in?

Robert

[William]

Hi,You need to use the corresponding adapter board, your adapter board should use capacitive sensors.

[156801]

Hi William do you have the part number Or link for the board that I need for the touch sensor so I cab buy it from your shop?