LCD Screen on Geeetech A30 Not working after firmware update
Posted: Fri Dec 28, 2018 3:18 am
Hello,
Just recently my A30 came in, and it was working OK (Autoleveling sensor wasn't working in firmware, but could print.). I pressed the button in the Easyprint3D software to Update the firmware, and the mainboard updated, but the LCD screen update failed, so now the LCD isn't working, meaning I can't level the bed and print. Through the Easyprint3D software I can't control the 3D printer right now, though mainboard updates are successful. I have tried a couple different ways to get it to work including:
Using the Smartto in order to put it on the Printer (Found the latest firmware on the page [1.35.56]) - LCD Timed out
There was a post on this forum about updating the LCD UI files through the SD Card, which I did (This one: https://www.geeetech.com/forum/viewtopi ... 65&t=60740)
I tried using the firmware toolkit (Here https://www.geeetech.com/forum/viewtopic.php?t=60814) but for the LCD it said uploading and then never had any status (Never posted a single percent)
And Easyprint 3d updater which didn't work as the mainboard it said worked but not the LCD. (Also worth noting, after trying updating Easyprint3d in the firmware updater still has an old firmware which didn't update listed for the current)
Right now I just need to get this printer working, as I am on a robotics team which needs certain parts printed out in the next 24 hrs.
EDIT: Just checked, Easyprint3D reads the current as 1.00.56 meaning that it thinks that the mainboard is fully updated but the LCD is on version 0
Thank you
Just recently my A30 came in, and it was working OK (Autoleveling sensor wasn't working in firmware, but could print.). I pressed the button in the Easyprint3D software to Update the firmware, and the mainboard updated, but the LCD screen update failed, so now the LCD isn't working, meaning I can't level the bed and print. Through the Easyprint3D software I can't control the 3D printer right now, though mainboard updates are successful. I have tried a couple different ways to get it to work including:
Using the Smartto in order to put it on the Printer (Found the latest firmware on the page [1.35.56]) - LCD Timed out
There was a post on this forum about updating the LCD UI files through the SD Card, which I did (This one: https://www.geeetech.com/forum/viewtopi ... 65&t=60740)
I tried using the firmware toolkit (Here https://www.geeetech.com/forum/viewtopic.php?t=60814) but for the LCD it said uploading and then never had any status (Never posted a single percent)
And Easyprint 3d updater which didn't work as the mainboard it said worked but not the LCD. (Also worth noting, after trying updating Easyprint3d in the firmware updater still has an old firmware which didn't update listed for the current)
Right now I just need to get this printer working, as I am on a robotics team which needs certain parts printed out in the next 24 hrs.
EDIT: Just checked, Easyprint3D reads the current as 1.00.56 meaning that it thinks that the mainboard is fully updated but the LCD is on version 0
Thank you