Why am i getting only partial prints?

Post Reply
martyray
Posts: 3
Joined: Tue Sep 01, 2020 1:02 pm

Why am i getting only partial prints?

Post by martyray » Sat Sep 19, 2020 9:18 pm

when using repetierhost V 2.1.6, i slice and preview the print.
it all look ok.
load it on to the card load it in the printer and commence the print.
the graph starts at 0% at the beginning of the print and by the time it reaches 100% the print is not completed.
it seems to only happen on multi colour prints..
all my single colour prints, regardless of the extruder im using print fine.
its only when i multi colour print.
i have tried multiple times and the pint stops at varying stages and the graph on the screen reads 100%.
the actual print is 15% to 50% completed.
what am i doing wrong?
id greatly appreciate any assistance.
i am about to try the print using cura, see what happens
thanks

victorbradford
Posts: 4
Joined: Sat Sep 26, 2020 1:45 pm

Re: Why am i getting only partial prints?

Post by victorbradford » Sat Sep 26, 2020 1:57 pm

There can be an issue with the caliberation of your printer as this is an important step to consider which a lot of people miss at the begginging but you can perform this at any time | from great assignment writing service - Professional writers

Post Reply

Who is online

Users browsing this forum: No registered users and 28 guests