Changing the nozzle

Post Reply
Heow
Posts: 0
Joined: Mon Mar 12, 2018 7:57 pm

Changing the nozzle

Post by Heow » Thu Mar 15, 2018 4:57 am

Hello,

I don't understand how to change the nozzle (to use the replacement part) on the E180. Is there a special trick to do this? I'm not seeing anything that I can pull/push to release the nozzle.
Pictures would be appreciated :)

Heow
Posts: 0
Joined: Mon Mar 12, 2018 7:57 pm

Re: Changing the nozzle

Post by Heow » Fri Mar 16, 2018 8:17 pm

Hi,

I had an answer from Jocelin from Geeetech, so I'm sharing the pictures with you.
The bit to pull didn't move when using my fingers, so I thought it couldn't move. Using a tool did the trick, I could pull it without problem and remove the nozzle. I didn't need to change the nozzle after all (wasn't cloged or anything) but I wanted to know how to do it...
Attachments
Geeetech-E180-Nozzle-Change2.jpg
Geeetech-E180-Nozzle-Change2.jpg (54.85 KiB) Viewed 7517 times
Geeetech-E180-Nozzle-Change1.jpg
Geeetech-E180-Nozzle-Change1.jpg (56.92 KiB) Viewed 7517 times

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: Changing the nozzle

Post by William » Mon Mar 19, 2018 7:15 pm

A more detail:
You should heating the nozzle up to 200C and then remove the filament off
Then you can try it and remove it off
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

rogerio53
Posts: 19
Joined: Mon Jul 09, 2018 4:17 am
Location: Portugal

Re: Changing the nozzle

Post by rogerio53 » Tue Jul 30, 2019 2:03 am

Hello. I cannot pull up the lever. What tool did you use. In case the lever is stuck may I use a bit of W40?

Post Reply

Who is online

Users browsing this forum: No registered users and 27 guests