Problems I am having with the E180

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Problems I am having with the E180

Post by William » Tue Jul 30, 2019 9:28 am

rogerio53 wrote:
Tue Jul 30, 2019 2:04 am
Hello. I cannot pull up the lever. What tool did you use. In case the lever is stuck may I use a bit of W40?
Hi, Are you referring to the bearing being stuck? You can lubricate it with proper lubrication.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

apak
Posts: 48
Joined: Fri Jul 20, 2018 4:01 pm

Re: Problems I am having with the E180

Post by apak » Thu Aug 08, 2019 8:56 am

The original PSU is able to manage a small heated bed...
I mod the e180 to another board, since smartoo src are useless and could mod the fw from the A30 to the E180 with heated bed, so I went for the skr1.3.

Now is printing even ABS at 90ºC heated bed, and 240ºC nozzle, with the stock psu.

https://www.thingiverse.com/thing:3680288
https://thingiverse-production-new.s3.a ... 653954.jpg

PATBAT009
Posts: 2
Joined: Mon Jun 03, 2019 1:22 am

Re: Problems I am having with the E180

Post by PATBAT009 » Sat Mar 28, 2020 11:08 pm

Hello, I am having a problem printing with my geetech e180. The problem is that when I print any piece it sticks too strongly to the base and when I try to stick it out the piece breaks. I´ve been looking for this problem on the internet but I haven´t found any soulution, do you have any idea for solving my problem?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Problems I am having with the E180

Post by William » Mon Mar 30, 2020 10:16 am

Hi, you can try to post textured paper,
Heat when removing the model and then remove the model with a shovel.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

allyree
Posts: 1
Joined: Sat Apr 18, 2020 11:40 pm

Re: Problems I am having with the E180

Post by allyree » Sun Apr 19, 2020 9:49 pm

i dont know if this has been addressed anywhere else, but i just got this printer but the bed has a very bad lateral wobble that makes it impossible to print anything. its like the rollers arent tight to the frame.

is there a fix for this?

Post Reply