Output voltage decreases in case of strain

Post Reply
Detlef
Posts: 14
Joined: Tue Nov 27, 2018 12:01 am

Output voltage decreases in case of strain

Post by Detlef » Tue Dec 04, 2018 3:53 am

When turning on the heating bed or an extruder, the output voltage for the power supply S-250-12 decreases from 12V to about 4.5 volts!
Is the power supply defective or can you set what?
Detlef

User avatar
_kaktus_
Site Admin
Posts: 1258
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Output voltage decreases in case of strain

Post by _kaktus_ » Tue Dec 04, 2018 4:37 am

Hello.
:mrgreen:

I suspect a short circuit somewhere, resulting in a voltage drop
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests