Change Filament / Resetting

Post Reply
ArnIIe
Posts: 5
Joined: Tue Feb 18, 2020 12:03 am

Change Filament / Resetting

Post by ArnIIe » Fri Feb 21, 2020 5:25 am

Sorry for n00b question....

I tried (for the first time) adding a pause so that I could swap filament half way through my print. The printer paused as I instructed (via Cura). But the Change Filament option wouldn't appear. Normally you choose Preheat PLA before, so I clicked that, but it gets itself stuck and then says heatign failed, reset printer - meaning I have a half finished print!

2 questions:

1) How do I effectively do this so that change filament option appears?
2) If a print fails for any reason, how do you restart the printer and get it to resume without scrapping the first bit?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Change Filament / Resetting

Post by William » Fri Feb 21, 2020 9:25 am

Hi,You can check whether your printer can choose to pause printing in the printer, and then replace the consumables. If the printing fails, you can restart the printer and move the nozzle to print again.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply