command waiting

Post Reply
alex.abate
Posts: 0
Joined: Mon Nov 27, 2017 2:42 am

command waiting

Post by alex.abate » Mon Nov 27, 2017 3:04 am

Hi, I started printing using repetier hosts and everything was fine, half of a job started to give error messages and after the printer give the message "command waiting" and doesn't move. I try to replace the firmware but nothing change.

User avatar
William
Site Admin
Posts: 4336
Joined: Tue Jun 07, 2016 9:38 am

Re: command waiting

Post by William » Mon Nov 27, 2017 11:59 am

Perhaps the reason for the USB cable, you can try to print with an SD card to see if the issue is solved.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

alex.abate
Posts: 0
Joined: Mon Nov 27, 2017 2:42 am

Re: command waiting

Post by alex.abate » Wed Nov 29, 2017 5:03 am

thanks William I'll try. Now the new thing is that the machine, after waiting message, loose the heating plate and the second extruder temperature is 100°C without command.

User avatar
William
Site Admin
Posts: 4336
Joined: Tue Jun 07, 2016 9:38 am

Re: command waiting

Post by William » Thu Nov 30, 2017 6:44 pm

Could you upload pictures of the wiring of mainboard?I also need to confirm what is displayed on the monitor.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

alex.abate
Posts: 0
Joined: Mon Nov 27, 2017 2:42 am

Re: command waiting

Post by alex.abate » Fri Dec 01, 2017 5:16 am

Hi, I print from SD and everything works right. still the problem with PC.
How can upload an image?
thanks

User avatar
Admin
Posts: 253
Joined: Wed Nov 30, 2011 9:49 am

Re: command waiting

Post by Admin » Fri Dec 01, 2017 12:01 pm

I think there may be the COM port is occupied in the middle of printing, of course, may also because of the USB cable and the interface.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests