configuration of Prusa I3 Pro B
Posted: Thu Jun 22, 2017 4:10 am
Hello community,
i bought me a prusa I3 abd built him up without problems. If I give him now elektricity an turn him on he runs.
then i installed repetier host and registered my prusa i3 on the repetierserver and connected him.
But now i dont know how i have to go on so that he starts printing.
If i try to move the Extruder threw the manual contole there happens nothing.
Dont i have to show the Extruder where he ist at the moment? because now the extruder sits anywhere on the half of y and z axis and at the end of the x axis.
Or do i just have to give the repetier host a 3D model and press print?
And which programm should i use to create the 3D models?
Sorry for all the questions but i couldnt find a manual to configurate the prnter
Lukas Radermacher
PS: Sorry for my bad english. i am a just a german student still learning english.
i bought me a prusa I3 abd built him up without problems. If I give him now elektricity an turn him on he runs.
then i installed repetier host and registered my prusa i3 on the repetierserver and connected him.
But now i dont know how i have to go on so that he starts printing.
If i try to move the Extruder threw the manual contole there happens nothing.
Dont i have to show the Extruder where he ist at the moment? because now the extruder sits anywhere on the half of y and z axis and at the end of the x axis.
Or do i just have to give the repetier host a 3D model and press print?
And which programm should i use to create the 3D models?
Sorry for all the questions but i couldnt find a manual to configurate the prnter
Lukas Radermacher
PS: Sorry for my bad english. i am a just a german student still learning english.