Layer Shifting A30M

Post Reply
USMCPelto
Posts: 7
Joined: Fri Sep 04, 2020 9:07 pm

Layer Shifting A30M

Post by USMCPelto » Thu Sep 17, 2020 4:21 am

If I throttle everything way down and super slow, to less than the default parameters, I can make semi-ok prints. There's still quality issues, but I'll work on those. If I use the default speed settings, the layers get way out of wack on the left to right layers (Y axis on the calibration cube). Any suggestions? The belt is tight. I'll work on the stringing issues later, for now I'd like to be able to move more than 30mm/s.

Post Reply

Who is online

Users browsing this forum: No registered users and 16 guests