Maybe problem with mains supply. Try UPS.aphocks wrote: ↑Sat Jul 30, 2016 1:00 amAfter examining the error more closely it appears that fro about three seconds all power is cut to outputs ie. fans, heaters, motors. the red heater light turns off, the steppers spin freely as if without power, and the fans stop turning the orange strobing lights that indicate data are still on though. Then everything starts working again but the print moves to a different spot. thoughts?
print jumps multiple times
Re: print jumps multiple times
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.