The rotary dial/encoder on my Geeetech LCD2004 no longer scrolls the menu. Depressing the knob to click still works though.
I did increase the voltage output on my PSU from 11.99v to 12.6v as I'd read it would help with my slow heatbed warm up time, not sure if that is the reason it stopped working or not. (I've since dropped the voltage back down, but the dial still doesn't scroll when turned).
How can I test it?
Dial on LCD2004 no longer scrolls
-
- Posts: 2
- Joined: Wed Jul 26, 2017 1:26 am
Re: Dial on LCD2004 no longer scrolls
DO you screw the knob tightly ,if that is ok,you maybe change a new LCD.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
- Posts: 2
- Joined: Wed Jul 26, 2017 1:26 am
Re: Dial on LCD2004 no longer scrolls
I agree with your idea that the dial may be out of work,but i am curious where you can find a new dial to replace the bad one,as I know,LCD is a whole.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!