Hi,
i have
Geeetech Acrylique Reprap Prusa I3 Pro B MK8
i lost the moderboard (wrong cablage: i puted the heat cable power between it place and the one of nozzle (in the middle))
it was GT2560 REV A
i chanded the motherboard from you: its GT2560 REV A+ (a little bit different from the first one)
i looks working fin
but LCD (YB2004D) couldn't start, i thouth it was burned too
i got this one https://www.amazon.fr/dp/B01N4QDAK9/ref ... 91_TE_item
but still not working
*/black screen,
*/makes noise when i click on the rotary
*/i tryed to change the contrast with the small thing in behind, no change
*/i did a framework update following one of the topics here
any suggestion?
LCD dont turn on, but makes sound when i click on the rotary
-
- Posts: 76
- Joined: Sun Mar 12, 2017 8:14 pm
Re: LCD dont turn on, but makes sound when i click on the ro
The cable for the SD card and the LCD screen are either in the wrong port or plugged in the wrong direction on the board.
Re: LCD dont turn on, but makes sound when i click on the ro
this was very helpful
thank you
the port are connected wrongly, i had to force the cables in the other direction, and the lcd looks fine now
but
i have a new problem
at least the direction of the motor X is wrong, i have to put it the other direction (0 toward the stoper)
i don't feel to invert the motor power shaft of X, as there is 4 pins not 2 (fearing to burn something)
thank you
the port are connected wrongly, i had to force the cables in the other direction, and the lcd looks fine now
but
i have a new problem
at least the direction of the motor X is wrong, i have to put it the other direction (0 toward the stoper)
i don't feel to invert the motor power shaft of X, as there is 4 pins not 2 (fearing to burn something)