Prusa I3 display stopped working

Post Reply
paulwhy
Posts: 10
Joined: Sun Jan 04, 2015 3:16 am

Prusa I3 display stopped working

Post by paulwhy » Tue Feb 03, 2015 11:44 am

I have a Prusa I3 Mendel Reprap from Geetech built from kit, with Arduino Mega, Ramps 1.4, A4988. I have had it only 1 month. the LCD2004 display stopped working. It was working fine, but ow it is just blank. The light comes on, but no characters. I tried pushing the reset button, but it does not do anything. I checked the wiring it is all correct. What is wrong? Is the display defective?

john
Posts: 104
Joined: Fri Nov 14, 2014 1:45 pm

Re: Prusa I3 display stopped working

Post by john » Tue Feb 03, 2015 2:53 pm

There is a adjustable resistance on the back of LCD board, screw it and see if something happen in the LCD.

Post Reply