I3 Pro C

Post Reply
Xaroos
Posts: 10
Joined: Sun Jul 09, 2017 7:48 am

I3 Pro C

Post by Xaroos » Sun Jul 09, 2017 8:07 am

Hi
I am assembling my I3 Pro ,in the wiring section it says connect X motor to here Y motor to there but no where it says which one X motor or Y motor,
The instruction that comes with it shows a video for assembling a similar printer but not exact like there is no mention of the fan that goes behind the print head I saw that in the picture on Ebay!
The whole instruction does not talk about using washers for screws but it comes with 105 washers!
There is no Mention of END STOP TRIGGER assembley which is hard to do after putting the head on.
I would like to have a picture of wire management too specially for the pars that are moving.
Thanks

Newopint95
Posts: 76
Joined: Sun Mar 12, 2017 8:14 pm

Re: I3 Pro C

Post by Newopint95 » Sun Jul 09, 2017 9:24 pm

what I3 Pro do you have?
The Y axis motor drives the bed.
The X axis motor drives the print head.

I can post some pictures of the cables on my I3 Pro B tomorrow.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: I3 Pro C

Post by William » Mon Jul 10, 2017 8:49 am

Newopint95 wrote:
Sun Jul 09, 2017 9:24 pm
what I3 Pro do you have?
The Y axis motor drives the bed.
The X axis motor drives the print head.

I can post some pictures of the cables on my I3 Pro B tomorrow.
I3 pro c ,titled in the top of the post.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: I3 Pro C

Post by William » Mon Jul 10, 2017 8:52 am

Could you attach a picture or a video about your assembling problems?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Xaroos
Posts: 10
Joined: Sun Jul 09, 2017 7:48 am

Re: I3 Pro C

Post by Xaroos » Mon Jul 10, 2017 3:20 pm

After going through the whole manual found all the wires but it would have been good to have a sketch of what goes where that the users dont have to waste so much time.

Post Reply