Heat Sink Instructions

Post Reply
wayneteresa
Posts: 12
Joined: Fri Sep 30, 2016 6:39 pm

Heat Sink Instructions

Post by wayneteresa » Sat Oct 01, 2016 7:33 am

I have purchased a Geeetech Rostock 301, I have found all the instructions to build the printer with a few common sense changes as instruction are not correct in some places :( , plus the kit only comes with 5 x M3 x 25 hex screws when you actually need 8 :( . my issue is I have tried to contact 3 different sections in geeetech with no replies for 3 days so far :(

one of the questions I am trying to find answer for is ..... on page 17 on one of the instructions, it states ;;;;;;; Don’t forget to stick the heat sink (#44) on the chip of the A4988 stepper motor driver
with sticker (#43).

wayneteresa
Posts: 12
Joined: Fri Sep 30, 2016 6:39 pm

Re: Heat Sink Instructions

Post by wayneteresa » Wed Oct 05, 2016 1:47 pm

I have now found the answer to my question about the heat sinks plus I went out and spent $2.90 and brought some replacement screws so I was able to finish builder my printer

ggg666
Posts: 38
Joined: Wed Aug 03, 2016 9:34 am

Re: Heat Sink Instructions

Post by ggg666 » Wed Oct 05, 2016 2:23 pm

Congratulations :)

User avatar
Lami René
Posts: 195
Joined: Mon Sep 26, 2016 6:47 pm
Location: Sherbrooke, Québec, Canada

Re: Heat Sink Instructions

Post by Lami René » Sat Dec 10, 2016 6:13 am

Hello,
Bonjour,

You will find the original text translated into English following this original French text.

Vous trouverez le texte original traduit en anglais à la suite du présent texte original en français.

Est-ce qu’aujourd'hui vous réussissez de belles impressions avec votre imprimante delta Geeetech Rostock 301 (M301) ?

Pas moi, j'ai acheté le 24 septembre 2016 !

Voir des pistes de solution dans le sujet suivant :

http://www.geeetech.com/forum/viewtopic ... 27&t=18578

Cordialement,

L'ami René
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hello,

Excuse me, I am unilingual francophone and I use Google translator to translate the texts of the forum in French and to write to you in English. Thank you for your understanding and your indulgence for these texts translated mechanically!

Do you make today beautiful prints with your Geeetech Rostock 301 (M301) delta printer?

Not me, I bought on September 24, 2016!

See possible solutions in the following topic:

http://www.geeetech.com/forum/viewtopic ... 27&t=18578

Cordially,

Friend René
Un pour tous et tous pour un !
One for all and all for one !
-------------------------------------
Mon imprimante modifié : http://forums.reprap.org/read.php?178,781375,781375
Voir aussi pour mes pièces : https://www.thingiverse.com/thing:2464177

Post Reply