How to wire Acrylic Geeetech I3 ?

Post Reply
carmelo42
Posts: 11
Joined: Wed Feb 11, 2015 10:48 pm

How to wire Acrylic Geeetech I3 ?

Post by carmelo42 » Wed Feb 11, 2015 10:57 pm

Hello,

juste received my Acrylic Geeetech I3 3D printer.

I have found the guide in the wiki to build the printer, but I don't see where are the instructions to wire all the cables and electronic ....

Can you please give me the link ?

Thanks !

Carmelo

wenganxiang
Posts: 3
Joined: Fri Feb 06, 2015 12:05 pm

Re: How to wire Acrylic Geeetech I3 ?

Post by wenganxiang » Thu Feb 12, 2015 9:48 am

Please tell me the type of mainboard. If you don't know its type. Send a picture to me.
By the way, I will give the wikipages of 2 types of mainboard, where you can find the wiring of mainboard.
http://www.geeetech.com/wiki/index.php/Ramps1.4
http://www.geeetech.com/wiki/index.php/Sanguinololu
You can see the wiring at the chapter 2.
The picture below shows how to connect the power unit.
initpintu_副本_副本.jpg
initpintu_副本_副本.jpg (122.35 KiB) Viewed 6018 times
QQ截图20150211092118.png
QQ截图20150211092118.png (195.88 KiB) Viewed 6018 times
QQ截图20150212094622.png
QQ截图20150212094622.png (381.93 KiB) Viewed 6018 times
If you still have any problem, reply me. You'd better add a pciture.

Post Reply