Problem with y axis...

Post Reply
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Problem with y axis...

Post by William » Fri Aug 30, 2019 3:17 pm

Hi, Can you provide your model?

You can try to swap the motor wires of other axes to the y-axis to see if the motor is running normally.
You can also exchange the drive board to try it out.
You can check this by doing this: http://www.geeetech.com/forum/viewtopic.php? f=17&t=17038

If there is no problem with the motor, you can check the tightness of the belt for proper adjustment;
Check if the bearing and pulley are issued (the card can be lubricated for lubrication)

I hope this can help you. :D
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply