Please share Prusa i3 A pro - M92 EEPROM - default Settings

Post Reply
Softbot
Posts: 3
Joined: Mon Jul 08, 2019 2:53 pm

Please share Prusa i3 A pro - M92 EEPROM - default Settings

Post by Softbot » Mon Jul 08, 2019 3:24 pm

Hi there,

I have messed up my M92 Settingin in the EPROM (Geeetech Prusa i3 A pro) and have not recorded the default setting :roll:

Can someone please share the default value, I would like to revert to default.

Command M503 will print the current value ... please see the guide below, I need the M92 / E setting
by https://mattshub.com/2017/04/19/extruder-calibration/

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Post by William » Mon Jul 08, 2019 3:46 pm

-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Softbot
Posts: 3
Joined: Mon Jul 08, 2019 2:53 pm

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Post by Softbot » Mon Jul 08, 2019 4:19 pm

Hi William,
I have saved wrong setting in the EEPROM using M500 command
Command 501 will restore the settings from the EEPROM or in other words the wrong settings I have saved before.
Im looking for is the factory value which have been set by geeetech, not sure if there is a repository to get the factory default values?
Thanks!

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Post by William » Mon Jul 08, 2019 4:21 pm

You can try resetting.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Softbot
Posts: 3
Joined: Mon Jul 08, 2019 2:53 pm

Re: Please share Prusa i3 A pro - M92 EEPROM - default Settings

Post by Softbot » Tue Jul 09, 2019 2:44 pm

Hi there,
I managed to restore settings using M502 (factory defaults) and saved setting using M500
This worked for me, all settings back and printer functional :D
The other hint was to check firmware conf file which must contain the default values ...
I found some factory values in conf file, but not my Extruder value "93" :roll: wondering which firmware is installed
Thanks!

Post Reply