Extruder temperature

Post Reply
Pusilanime
Posts: 3
Joined: Fri Dec 22, 2017 12:45 pm

Extruder temperature

Post by Pusilanime » Mon Jan 29, 2018 10:47 am

Hi, I didn't find any thread about this issue, then I ask for help hier
The printer works well and then, randomly After a few minutes the hotend stops heating. Temperature goes to 0 gradually and Display shows for example EXTRUDER TEMP 200/0, while before was 200/200
I tried 3 times and always have the same Problem. Extruder doesn't work anymore after a few minutes because of the temperature of the hotend.
What could be the problem?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Extruder temperature

Post by William » Mon Jan 29, 2018 8:01 pm

Have you tried to check the wiring of Extruder?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Pusilanime
Posts: 3
Joined: Fri Dec 22, 2017 12:45 pm

Re: Extruder temperature

Post by Pusilanime » Mon Jan 29, 2018 8:32 pm

Problems started last week, before that was all right.
I checked the wiring :

https://photos.app.goo.gl/SRl5i5kAeOuF34on1

Pusilanime
Posts: 3
Joined: Fri Dec 22, 2017 12:45 pm

Re: Extruder temperature

Post by Pusilanime » Mon Jan 29, 2018 8:37 pm

PS: printer OFF

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Extruder temperature

Post by William » Tue Jan 30, 2018 9:45 am

It seems not normal(Normal is 1~6Ω)
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Pusilanime
Posts: 3
Joined: Fri Dec 22, 2017 12:45 pm

Re: Extruder temperature

Post by Pusilanime » Tue Jan 30, 2018 12:18 pm

[quote=William post_id=82343 time=1517276719 user_id=51382]
It seems not normal(Normal is 1~6Ω)
[/quote]

Are you saying, that the problem is on the wiring?
If yes, is there a video explaining how to repair/change the cables?

Pusilanime
Posts: 3
Joined: Fri Dec 22, 2017 12:45 pm

Re: Extruder temperature

Post by Pusilanime » Wed Jan 31, 2018 10:58 am

What are you saying?
I have a broken cable? How can I fix it please?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Extruder temperature

Post by William » Thu Feb 01, 2018 9:46 am

It seems you need a new heating bar
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply