Hello,
I have finished building and calibrating my printer but cannot seem to get the extruder-stepper motor to work. I cannot seem to be able to test it on Repetier or from the G2's LCD controls. I have had my printer for just over 2 weeks and am still unable to print.
I would really appreciate the help and assistance.
Kind regards,
Z
G2 Extruder Motor
Re: G2 Extruder Motor
Try to examine your extruder motor wires,did they connect correct?
Or did you plug in the jumper caps to the motors?
Or did you plug in the jumper caps to the motors?
Re: G2 Extruder Motor
Hi Mark,
I examined the wires and was able to fix it I think, I was able to head the extruder and got the servo to move the filament up and down using the LCD controls on the G2, however, I cannot seem to be able to print, I did not receive an endstop for my hotend nozzle but customer service assured me I could print without it but I do not understand how nor was I told. I'd really appreaciate some help with this issue too, youve helped me troubleshoot so many times. Thank you.
I examined the wires and was able to fix it I think, I was able to head the extruder and got the servo to move the filament up and down using the LCD controls on the G2, however, I cannot seem to be able to print, I did not receive an endstop for my hotend nozzle but customer service assured me I could print without it but I do not understand how nor was I told. I'd really appreaciate some help with this issue too, youve helped me troubleshoot so many times. Thank you.