A solid machine

Post Reply
vinay456
Posts: 1
Joined: Fri May 08, 2020 5:55 pm

A solid machine

Post by vinay456 » Fri May 08, 2020 6:59 pm

Flashed marlin 2.0 from vertbreaker added a bl touch, a “better” cooling duct, and a purge “bucket” to use instead of prime towers and a piece of mirror to print on are the only modifications to the printer I have made. The prints that have come off this machine have been great for the profile I have used.
Pros:
its got a good build volume of 255x255x255
power supply and motherboard mounted underneath covered with a plate from front to back so no accidental touching of electronics.
dual bearings in each vslot wheel for stability
hotend breakout board makes connecting bltouch sensor easy

Post Reply

Who is online

Users browsing this forum: No registered users and 36 guests