Page 3 of 3

Re: Problem reading temperature Rambo Board

Posted: Thu Jul 03, 2014 6:14 pm
by techsupport
you can test the r32 r37 r28 r39 is solded well。the min temp err means that the thermistors is not connected well with mega2560.it is open circuit。

Re: Problem reading temperature Rambo Board

Posted: Fri Jul 04, 2014 1:17 am
by daxer70
I'm not expert in dmd soldering, I've only tested all the resistors with the multimeter and always got around 4.3 k value

Re: Problem reading temperature Rambo Board

Posted: Fri Jul 04, 2014 3:37 pm
by techsupport
Please see the attached figure,You provide resistance value is normal,
You can check the electronic circuit is normal? waiting your reply.
Best regards

Re: Problem reading temperature Rambo Board

Posted: Sat Jul 05, 2014 1:46 am
by daxer70
To much complicated for me…

between T0 pins I have around 9 k ohm, the same on T1

cannot test further