stepper motor replacement, duplicator 5

Post Reply
v923z
Posts: 1
Joined: Fri Jan 18, 2019 4:43 am

stepper motor replacement, duplicator 5

Post by v923z » Fri Jan 18, 2019 5:10 am

Hi all,

I have just purchased my first geeetech printer, and it seems that the kit was not properly packaged, so the axle of the Y stepper motor (number 51 in the manual) is reversed (tapped holes are on the same side as the cogwheel), and therefore, the motor can't be mounted on the frame. Does anyone happen to know, what the part number of the correct motor is. I don't want to send back the printer, I would just buy a replacement motor.

Thanks,

Zoltán

Post Reply