Changing the extruder drivers to LV8729
Changing the extruder drivers to LV8729
I was thinking about changing the drivers, but when Looked under the existing chip there are no jumpers to set the microstepping. How is microstepping set on this V4 board.
Re: Changing the extruder drivers to LV8729
Hi, there are no jumper caps on the V4 board.
You can try changing the driver board to TMC2208.
You can try changing the driver board to TMC2208.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!