Head Extruder Wire connection

Post Reply
cala
Posts: 8
Joined: Sun Dec 22, 2019 4:23 am
Location: Switzerland

Head Extruder Wire connection

Post by cala » Sat Mar 21, 2020 11:53 pm

Hi,

I have buy a new extruder for my A20T. Do you have the connection schema with the board ?
I have try to reconnect like the preview one was connected, it heat but not working well.
The PLA is not pushing out correctly.

I'm pretty sure is my wire connection wrong.

Thanks in advance

Best regards

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Head Extruder Wire connection

Post by William » Mon Mar 23, 2020 10:40 am

Hi, you can view it according to the wiring diagram:
GT2560 V4.0主板接线图.jpg
GT2560 V4.0主板接线图.jpg (617.34 KiB) Viewed 8389 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

cala
Posts: 8
Joined: Sun Dec 22, 2019 4:23 am
Location: Switzerland

Re: Head Extruder Wire connection

Post by cala » Thu Mar 26, 2020 8:40 pm

Hi,

Thanks. I think is not clear my message. My issue it's with the part 3 in 1 out hotend kit for A10T A20T (SKU:700-001-1265).
Sometimes the filament go out, sometimes not. The temperature seams OK : 215 °C for PLA. Filent 1 it's working but the others 2 color nothig is going out. the motor pushing the filament it's working.

I have buy a new one to replace the existing. My printer is new and can't do nothing with. When I have receive the printer, the model from the card have work fine. Now also the model it's not print correctly.

Best regards,

Calà Salvatore

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Head Extruder Wire connection

Post by William » Fri Mar 27, 2020 10:18 am

Hi, Hot end installation,
You need to install the hot end into the heating cage,
For the transfer board part, you can refer to:
转接板的对应.png
转接板的对应.png (630.91 KiB) Viewed 8352 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

cala
Posts: 8
Joined: Sun Dec 22, 2019 4:23 am
Location: Switzerland

Re: Head Extruder Wire connection

Post by cala » Wed Apr 15, 2020 2:20 am

THANKS. SOLVED.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Head Extruder Wire connection

Post by William » Wed Apr 15, 2020 11:56 am

:D
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply