Sensor misses bed

Post Reply
mahkingmi
Posts: 1
Joined: Tue Sep 03, 2019 11:52 am

Sensor misses bed

Post by mahkingmi » Sat Sep 07, 2019 3:40 am

Hi,

I installed the 3d touch sensor and then flashed the software useing packet on geeetech website, but when i run auto level the needle will try and test in a spot that is off the bed. So the center one works, then the front, then other middle, but the first rear test point misses the bed completly. I am not sure how to fix this. Has anyone run into this problem?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Sensor misses bed

Post by William » Mon Sep 09, 2019 9:23 am

Hi, Are you calibrating 3d touch? you can refer to this;http://www.geeetech.com/wiki/index.php/ ... ing_Sensor
Is the correct firmware installed?

If all of the above are correct but the hot bed is still missing,
You can provide specific videos
so that we can solve the problem better.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply