A20M and Simplify3d

Post Reply
rogerio53
Posts: 19
Joined: Mon Jul 09, 2018 4:17 am
Location: Portugal

A20M and Simplify3d

Post by rogerio53 » Fri Aug 16, 2019 8:41 pm

Hello. I have an A20M printer. I have a problem with the extruders. I know that CURA is not good with the 2in1 ends, so I decided to try Simplify3D. Small models work well but on larger models at some point one of the extruders stops and the print goes on always with the same filament. It happened twice and each time with different extruders. After print finishes I have difficulties to use the extruded that stopped. Contacted Simplify3D support and it seems that cgode generated the correct commands to change extruders. Can anyone help? Thank you.

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: A20M and Simplify3d

Post by William » Sat Aug 17, 2019 9:11 am

Hi, Can you provide a specific video or picture?
So that we can solve the problem better.

If you use it for monochrome printing,
you also need to insert consumables on the two hot ends to prevent nozzle clogging.

For the hot end cleaning, you can refer to this video:https://www.youtube.com/watch?v=oBRXsBmZ9_U
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

rogerio53
Posts: 19
Joined: Mon Jul 09, 2018 4:17 am
Location: Portugal

Re: A20M and Simplify3d

Post by rogerio53 » Sat Aug 17, 2019 8:06 pm

I will try again tomorrow and take some pictures.
Thank you.

Post Reply

Who is online

Users browsing this forum: No registered users and 22 guests