Good morning, everyone,
i just bought a geeetech A20 with PLA Geeetech and i can't finalize the printing of an object
After a few coats the PLA on the tray peels off and mixes with the current print.
Any ideas?
Thanks for you help
Ultimaker Cura with A20 profil and geeetech PLA profil
Regards
the PLA comes off the platen during printing
-
- Posts: 2
- Joined: Fri Apr 17, 2020 4:05 pm
the PLA comes off the platen during printing
- Attachments
-
- geeetech issue.png (28.73 KiB) Viewed 7983 times
Re: the PLA comes off the platen during printing
Hi,you can check if the bed is flat ,deformed or clean.
Mabey signs the first layer print temperature is incorrect,
Printing colder will decrease adhesion. Printing hotter (to a point) will increase adhesion.
Mabey signs the first layer print temperature is incorrect,
Printing colder will decrease adhesion. Printing hotter (to a point) will increase adhesion.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
- Posts: 2
- Joined: Fri Apr 17, 2020 4:05 pm
Re: the PLA comes off the platen during printing
Merci pour la réponse je vais vérifier