A20 Loose Bed

Post Reply
EHT_Australia
Posts: 2
Joined: Fri Oct 18, 2019 6:15 pm

A20 Loose Bed

Post by EHT_Australia » Fri Oct 18, 2019 6:23 pm

Hello,

My A20's bed is not secure and has about 1mm play on the front left and rear right corners. It seems that the chamfered wheels are not pressing up against the Y_Track firmly.

Question: How do I adjust them so that the bed doesn't rattle ?
For that matter, how do I get to them ?
How does one remove the bed plate ?

User avatar
vert
Site Admin
Posts: 735
Joined: Wed Nov 21, 2018 3:50 pm
Location: INDOORS

Re: A20 Loose Bed

Post by vert » Fri Oct 18, 2019 7:13 pm

EHT_Australia wrote:
Fri Oct 18, 2019 6:23 pm
Hello,

My A20's bed is not secure and has about 1mm play on the front left and rear right corners. It seems that the chamfered wheels are not pressing up against the Y_Track firmly.

Question: How do I adjust them so that the bed doesn't rattle ?
For that matter, how do I get to them ?
How does one remove the bed plate ?
adjusting the ecentric nut on the bottom of the bed.
Image
Get The Current Marlin 2.0 Build For Almost All Geeetech 3D Printers Here
A10 M D T/A20 M T/I3PRO A B C W X/E180/A30/Mecreator2/M201/D200

EHT_Australia
Posts: 2
Joined: Fri Oct 18, 2019 6:15 pm

Re: A20 Loose Bed

Post by EHT_Australia » Fri Oct 18, 2019 8:05 pm

Yes!
THANK YOU :-)

rwlroc
Posts: 4
Joined: Sun Oct 20, 2019 12:30 pm

Re: A20 Loose Bed

Post by rwlroc » Sun Oct 20, 2019 12:36 pm

I just assembled my A20M and I have even more play in the bed than that. Nearly 1cm of play. A bit disappointing out of the box. I will try the adjustment suggested.

rwlroc
Posts: 4
Joined: Sun Oct 20, 2019 12:30 pm

Re: A20 Loose Bed

Post by rwlroc » Sun Oct 20, 2019 11:42 pm

That did the trick

User avatar
vert
Site Admin
Posts: 735
Joined: Wed Nov 21, 2018 3:50 pm
Location: INDOORS

Re: A20 Loose Bed

Post by vert » Mon Oct 21, 2019 6:53 am

Image
Get The Current Marlin 2.0 Build For Almost All Geeetech 3D Printers Here
A10 M D T/A20 M T/I3PRO A B C W X/E180/A30/Mecreator2/M201/D200

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests