Geeetech

Hi,you can check this post:http://www.geeetech.com/forum/viewtopic ... 19&t=17039.

Pleasure to hear you have solved your problems.

Congratulations, thank you for your selfless sharing .

Hi,you can check this post:http://www.geeetech.com/forum/viewtopic ... 17&t=17038

My Z axis motor tries to work but it will not move. I replaced my threaded rods with lead screws to increase quality of print and My z motor will try to spin but will not spin at all. when i try to make the z axis go up or down i can feel the motors trying to work but they do not ever actually spin...

I fixed to solder. I also reloaded firmware. Still nothing from the extruder. Now my axises are reversed so I'll have to fix that. Changing the nozzle didn't fix the issue with the first extruder. I ordered a different extruder setup now if can get the main board fixed I might be ok. The board migh...

Hi,the hotend of M201 may be clogged,please disassemble it to check.There is a related post you can refer to:http://www.geeetech.com/forum/viewtopic ... 19&t=17616.

Hi there, I have built a prusa i3 3d printer and I have been testing it. Every time I try to print the ground layer is good, but when the actual body of my piece is being printed my extruder is extruding too slow. I can see the PLA is sometimes passing and sometimes not. When I manually force the f...

Good morning! I finally endend building my first 3D printer, a Geeetech Prusa i3 X, and when I'm turning on, the LCD shows "Err : MINTEMP" with "0/0°" for the extruder, and room temp is OK. Repetier-Host shows : 11:25:47.975 : Error:0 11:25:47.975 : : Extruder switched off. MINTEMP triggered ! 11:2...

Hello, i got that problem that the extruder motor doesent move. It`s not defective. I interchanged motor, driver and kabel. Works on all other ports and driver but not on E0 and E1. I allthough flashed the firmware for those who have broken E0 port. Still not working. Got 12.5 volts on E0 and E1 pi...