Geeetech

Hello.


Be careful, the GTM32 vB Controller may not be compatible with the successor to the GTM32 Pro vB.

All available diagrams are shown in the forum. Subforum Control board.
However, there is no schematic you need.

I will try to ask if it can be shared.

Hi.


Read the information from our subforum about the M201 model.
Two cases have been identified and resolved by me.

I don't know if you know but a stopped/interrupted printout can be continued.

Hi. :mrgreen: You can use the procedure from friend Tparent, as described in our forum. You can also try out compilations from the vert colleague. Everything is in one topic. :D These presentations are related to Marlin firmware version for MCU 32bit. However, I suppose this modification will depriv...

Hi.


I really like to read your posts.
The coolest thing is that you solve a lot of problems yourself.
You forget about one fact, you gain invaluable knowledge and skills.
You become a professional user.

"One more minute" and nothing else will surprise you.

Hi.

You don't have to make any extra purchases.
Get interested in the alternative version of the firmware.

Personally, I think that "automatic" levelling is not indispensable in this model.

Hello.


I can only say that:
Company firmware, firmware doesn't support this gadget.


But I'm sure you know that.

Hi.


Tell me if you were able to maintain the functionality of the mixer in your firmware.

Hello.


When your printer is new, print slowly. You can increase the printing speed over time.
You will gain experience and the mechanisms of your printer will be adjusted.

Hello Jhonmicky.


You must be guided by the data provided by the manufacturer of the Filament you are using.

Basically I print at temperatures:

• heated bed 90°C
• hot end 240°C

To improve adhesion to the substrate I use Dimafix spray.


My printer has no shield or heat casing.

Hi :mrgreen: There are a few points I'd like to agree with you on... ;) Better quality control would save you many recurring problems. These problems are faced by both novice users and those for whom the printer is not new. Then an opinion is created about the brand and the company. While a novice c...