Geeetech

Hi everybody. I'm looking for info about board lcd pin out to change it with tft. I think, if will be possible to work around pin on Marlin

@vert

Tks for your answer, I've only another question. The sensor I've bought arrived with the wiring in picture, Could I wiring directly on 3wires' attach rear hotend? I've a A10M printer

Blue GRN
Brown +V
Black Z min

Now I'm gone to next Ubuntu 19.04 and ssems all get well
Edit
I've deleted snap version of 1.8.5 ide and installed from tarball placed on Android site

Hi, everybody. I've bought this probe Sensore di prossimità induttivo per Stampante 3D PNP NC 5v - Distanza rilevamento 4mm - Compatibile Ramps1.4 - LJ12A3 5V https://www.amazon.it/dp/B07HWY6D3V/ref=cm_sw_r_cp_apa_i_D6NFCbZWJ1F5K I know I must to change marlin configure.h, but, someone have a quick ...

@vert

The problem is this, with A10 all work fine, with A10M don't work. I've found a thread about issue between kernel and module CH431. I couldn't try because I'm out on work. Tonight I'll try replace Arduino IDE, and/or module

Hi. I'm a happy owner of A10M. I want to try to use 3dtouch sensor. I need to upload Marlin, on Ubuntu 18.10 (but also I've a ussue on Win Xp) seems something go wrong, cause I recive a send error on usb. I've gived all permission (Repentier work fine), but I can't use USB for flash. Someone could h...

@ _kaktus_

Yes, ok, but if board could be lcd o tft connected, schematic maybe lead me to understand pinout

@ William

Tks for your help, I don't know if where you live is midnight or no .
About your kind answer, I've decifrate sch file like schematic, and I've, and UART fw, like UART forwarting? Right? I want to look out also the GTM32 schematic. If I not mistaken, the board use tft instead lcd.

@ _kaktus_

Seems is a direct flow you <=> me.
What I'm looking for is a schematic of the gray strip wiring board <=> lcd, so I can understand if is possible to do a pcb to connect tft-pcb-board

@ _kaktus_

Maybe I explained myself wrong. I have already used steppers for other projects, I was just wondering if there are problems using 1A engines instead of 0.4A?