Geeetech

My printer is in another room, is there a way to use the USB port on wifi or extender.?

So put the glue stick or hair spray on the metal bed, between the mylar. or put it on top of the mylar.?

This is the default Dog code that comes with the printer, A10M

Can someone tell me why this happened, is there a correction for it.?

https://ibb.co/KsV734W

So I have seen several projects where it appears to have a sponge with the filament passing thru it.
Is this to moisten the filament or clean it.

Is it required or suggested.?

Thanks

Thanks for the reply.

This is A10M

I used one roll of filament, on E1.

The issue is I printed again and the same problem. The top of the DOG is garbage.

I just took off the sensing of filament and loaded a different model, all is good again

When I power on an tell it to priont from SD car. The A10M beeps, then the temp starts to rise. Then I see the Z axis flashing a ? Then the following message: Heating failed PRINTER HALTED Please reset. I have reset power several times, and it does the same thing. What is eeprom initialize do? thanks

The pad does come off, but the model on top is like keeping it from removing from the aluminum.

So, this is my first print, and I have no idea why this happened.

Can someone tell me what needs adjusting and why it happened.?

https://ibb.co/N36yd8C

Also after cooling off, the model will not come off the table.

Noobie here !
I noticed for the new firmware there are 2 version to download.

I ordered an A10 but how do I tell which is best for me.

A10M-Marlin-1.1.9-3d-touch.hex.zip

A10M-Marlin-1.1.9-standard.hex.zip

Which of the above should I take?

Thanks