Geeetech

hi, How long and why do we need to wait for it? What about Marlin 2.0? I am not very hopeful because even for old Marlin there is no profile published. I have to rely on Marlin 1.1.8 hex file which sucks because I can not do any modifications. There is some example profile for A10T but they are simp...

Hi William,

you posted these schematics before and there are no very helpful, there are just not detailed enough.

Where can I find detailed schematics for GT2560 V4.0?
and
Whare can I find pin assignment (pins_GT2560_V4.0.h file) for GT2560 V4.0?

Cheers
Andrzej

Hi, I have installed TMC 2208 in STANDALONE mode for E0, X, and Y. The problem occurs in extruder only with skipping steps at moderate speeds. So I would like to at least one or two (I have 3) extruders in UART mode. Apparently nobody did it before me... or? Please help! What I would appreciate is g...

Hi, even if you would manage to make stepper move it would miss-steps. I have this problem so I am trying to connect it in UART mode. I cant find anywhere GT25600 V4.0 schematics (detailed!) that I could use to find where I can connect communication. Also file pins_GT2560_V4.0.h doesn't exist. In 20...

Hi,

Topprinter what mode did you set up (Standalone, OTP or UART)?
If it works for XYZ then you might have a faulty driver or not connected properly, try swapping E with Z and see.

Cheers
Andrzej

Hi,

What about A10T with GT2560 V4.0?
Can I do UART with TMC 2208?

Cheers
Andrzej

Hi,

thanks for reply.
It will not melt even at 250C. I have to remove the heatbreak. Perhaps I will have to even replace it with new one.
Any suggestion how can I remove it?

Hi, I did a mistake of leaving PLA in extruder nr 2 while using ABS in extruders nr 0 and 1, the connector which is placed in the heatsink got clogged, solidified and this will not melt. I want to remove this connector from HotEnd. I have unscrewed 2 screws (2 in 1 hole - screw nr 3and4) which secur...